M22 Female to 3/4" GHT Male Hose Adapter (2 Pack)

• Universal Compatibility – Fits Most Pressure Washers
  Connects your pressure washer to a standard garden hose. Compatible with most brands using M22 fittings.
• Leak-Proof Seal – No More Puddles
  Precision-cut threads and a premium O-ring deliver a tight, drip-free seal. Full pressure, zero waste, drier workspace.
• Heavy Duty Brass – Withstands High Pressure
  Solid brass resists rust, corrosion, and deformation up to 5000 PSI. Far more durable than plastic fittings.
• Simple & Secure Thread-On Installation
  Standard screw-on design creates a rock-solid mechanical lock. Robust threads prevent accidental disconnection under vibration.
• Compact, Rust-Proof & Cost-Effective
  Corrosion-resistant finish withstands moisture. Leave them attached outdoors without worry—perfect for replacing lost connectors.

Why Choose This M22 to Garden Hose Adapter?

What "M22" and "GHT" Actually Mean

M22 is the metric fitting found on most pressure washer pumps—22mm diameter with fine threads. GHT (Garden Hose Thread) is the standard U.S. garden hose threading. These two standards don't connect directly, which is why this adapter exists.

How to Confirm You Need This Adapter

Check both ends. Your pressure washer inlet should be M22 male (threads outside). Your garden hose should be 3/4" GHT female (threads inside). If your hose has a male end instead, you'll need the female version of this adapter—see the link below.

When to Use This Adapter

Use it when you want to run your pressure washer from a garden hose—common for car washing, patio cleaning, and driveway rinsing where a full pressure washer hose isn't practical. Also handy for RV owners using campground water.

Brass vs Plastic at High Pressure

Pressure washers push water at up to 5000 PSI. Plastic adapters can crack or blow off under that load, especially after UV exposure. Solid brass holds its shape and threads under pressure—which is why every serious pressure washer setup uses brass fittings.

Installation Tips

Hand-tighten the M22 side first, then a quarter turn with a wrench if needed—don't overtighten, as M22 threads are fine and can strip. The GHT side uses the built-in O-ring, so no PTFE tape is needed. If it drips at the M22 connection, check that the O-ring is seated flat.

Specifications

FAQs

Q1: What does "M22 Female to 3/4" GHT Male" mean?
A: The M22 end has inside threads (female) and connects to your pressure washer. The GHT end has outside threads (male) and connects to a garden hose with a female end.

Q2: Will this fit my pressure washer?
A: It fits most pressure washers using M22 fittings. Check your washer's connection type before ordering.

Q3: Can it handle high pressure?
A: Yes. Solid brass construction withstands up to 5000 PSI without deformation.

What's in the Box

• 2 × M22 Female to 3/4" GHT Male Hose Adapter
• 2 × O-Rings (pre-installed)

Looking for a Different Connection Type?

This adapter is M22 Female to 3/4" GHT Male. If your garden hose has a male end instead, you'll need the female version:

• M22 Female to 3/4" GHT Female Adapter — connects to a male-ended garden hose

Or browse all GHT Connectors & Valves.